adding oil SMART FORTWO COUPE 2011 Owners Manual

Page 8 of 228

Driving and parkingSafety notes .............................. 78
Driving safety systems .................... 46
ABS ........................................ 46
ESP ®
....................................... 47
Hydraulic brake assistant ...........48
E
Electrical system Improper work on or
modifications ........................... 15
Power outlet ............................ 115
Electronic immobilizer .................. 48
Display message ....................... 161
Electronic Power Steering
see EPS
Electronic Stability Program
see ESP ®

Emergency, in case of
Hazard warning flasher ..........48, 68
Roadside Assistance ..................14
Emergency operation (limp-home
mode) .......................................... 86
Emergency Tensioning Device see ETD
Emission control .......................... 152
Information label ..................... 213
System warranties ......................13
Engine
Break-in recommendations .........118
Compartment ........................... 119
Compartment cover .................... 119
Electronics ............................. 212
Malfunction indicator lamp ........173
Number .................................. 215
Starting .................................. 78
Turning off .............................. 81
Engine coolant
see Coolant
Engine oil
Adding ................................... 121
Additives ............................... 221
Checking level ......................... 120
Consumption ........................... 120
Oil dipstick ............................ 121
EPS (Electronic Power Steering)
Warning lamp .......................... 169
ESP®
(Electronic Stability Program) ... 47
Warning lamp .......................... 169
ETD (Emergency Tensioning Device) ... 33
Safety guidelines ......................35
Exterior lamp switch ...................... 64
Exterior lighting Overview ................................ 181
Exterior rear view mirrors .............. 61
Exterior view of vehicle .................. 20
F
First-aid kit ............................... 160
Flat tire ..................................... 188
Fluids Capacities ............................. 220
Engine coolant ........................ 220
Engine oil .............................. 220
Fog lamps ................................ 68, 181
Front air bags see Air bags
Front compartment ........................ 122
Front lamps Overview ................................ 181
Fuel ........................................... 148
Additives ............................... 222
Capacity, fuel tank ...................220
Fuel filler flap and cap .............118
Fuel level display .....................90
Premium unleaded
gasoline ..................... 119, 220, 221
Refueling ............................... 118
Requirements .......................... 222
Fuel cap
Indicator lamp ......................... 172
Fuel filler flap ............................. 118
Fuel level display .......................... 90
Fuel tank Capacity ................................ 220
Fuel filler flap and cap .............118
Refueling ............................... 118
Fuse chart ................................... 207
Fuses ......................................... 204
6IndexBA 451 USA, CA Edition A 2011; 1; 4, en-UShereepeVersion: 3.0.3.62010-05-11T15:12:26+02:00 - Seite 6

Page 124 of 228

XCheck the engine oil level once more.XAdd engine oil once more if necessary.
Be careful not to spill any oil when adding
to avoid environmental damage caused by
oil entering the ground and water.
! Excess engine oil must be siphoned or
drained off. It could cause damage to the
engine or emission control system not
covered by the smart Limited Warranty.
XScrew filler cap \000F back on the filler
neck.
XClose the engine compartment cover
(Y page 119).
Front compartment
Service flap
Remove the service flap to check the
coolant level, windshield washer reservoir
level, and brake fluid level.
Insert the service flap on the front of the
vehicle so that it does not get damaged or
dirty.
iThe service flap has a strap on the rear
side that ties it to the vehicle body.
GWarning!
Always turn the key to starter switch
position 0 and remove the key from the
starter switch before opening the service
flap.
If the windshield wipers should
inadvertently be switched on, you could be
seriously injured by the wiper washer
drive, which is located just below the
service flap.
GWarning!
Make sure the service flap is locked while
driving. Otherwise, the service flap could
become detached and pose a hazard to you
or others.
GWarning!
To help prevent personal injury, stay clear
of moving parts when the service flap is
open.
The radiator fan may continue to run for
approximately 30 seconds or may even
restart after the engine has been turned
off. Stay clear of fan blades.
! Check the fill levels at regular
intervals.
! Carefully remove ice, snow, and any
other deposits from the air intake
grilles above the service flap to ensure
air intake at all times.
XPark the vehicle on level ground.XTurn off the engine.XEngage the parking brake.
Removing
XFold both levers \000G outward in direction
of the arrows \000

Page 225 of 228

are prohibited when windshield washer
concentrate is being handled.
Coolants
The engine coolant is a mixture of water
and anticorrosion/antifreeze, which
provides:
R Corrosion protection
R Freeze protection
R Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -35 ¦ (-37 ¥) and
corrosion protection.
! Add premixed coolant solution only.
Adding water and MB 325.0
Anticorrosion/Antifreeze separately
from each other, could cause engine
damage not covered by the smart Limited
Warranty.
If the antifreeze mixture is effective to
-35 ¦ (-37 ¥), the boiling point of the
coolant in the pressurized cooling system
is reached at approximately 266 ¦
(130 ¥ ).
The coolant solution must be used year
round, even in countries which have high
temperatures to provide the necessary
corrosion protection and increase
boil‑over protection. Refer to
Maintenance/ Service Booklet for
replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance booklet is only applicable if
MB 325.0 Anticorrosion/Antifreeze
solution or other smart approved products
of equal specification are used to renew
the coolant concentration or bring it back
up to the proper level.
For information on other smart approved
products of equal specification, contact an
authorized smart center.
To provide important corrosion
protection, the solution must be at least
50% anticorrosion/antifreeze (equivalent
to freeze protection to approximately
-35 ¦ [-37 ¥]).
If you use a solution that is more than 55%
anticorrosion/antifreeze (freeze
protection to approximately -49 ¦
[(-45 ¥]), the engine temperature will
increase due to the lower heat transfer
capability of the solution. Therefore, do
not use more than this amount of
anticorrosion/antifreeze.
If the coolant level is low, water and
MB 325.0 Anticorrosion/Antifreeze should
be used to bring it up to the proper level
(have cooling system checked for signs of
leakage). Please make sure the mixture is
in accordance with label instructions.
Always use anticorrosion/antifreeze that
have been approved by smart. For
information contact an authorized smart
center.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water.
If you are not sure about the water quality,
consult an authorized smart center.
Anticorrosion/antifreeze
Your vehicle contains a number of
aluminum parts. The use of aluminum
components in motor vehicle engines
necessitates that anticorrosion/
antifreeze coolant used in such engines be
specifically formulated to protect the
aluminum parts.
Failure to use such anticorrosion/
antifreeze coolant will result in a
significantly shortened service life.
Therefore, the following product is
strongly recommended for use in your
Service fluids and capacities223>> Technical data.BA 451 USA, CA Edition A 2011; 1; 4, en-UShereepeVersion: 3.0.3.62010-05-11T15:12:26+02:00 - Seite 223Z